For Quality Care
Call Anderson Air
Rated 4.9 out of 5.0 online
HVAC Maintenance Plans in Northwest Arkansas
Keep Your HVAC Costs Under Control with the Anderson Club
Anderson Air Club Membership is complete protection for your Heating and Air Conditioning system as well as your pocket book! An annual membership for you HVAC system will increase the lifespan of your furnace and air conditioner, decrease system breakdowns, save you money and help save the earth by lowering gas and electricity consumption!
Benefits of Joining the Anderson Club
The Anderson Club is among the most comprehensive HVAC maintenance plans in Northwest Arkansas. Benefits include the following – all for just $199 annually ($179 per additional HVAC unit) or monthly: $19/month for the first unit and $17/month for each additional unit.
✔ 2 Free System Tune-Ups Or Maintenance Checks (Fall & Spring)
✔ Discounted Service Fee Of $49
✔ 10% Off Of Parts And Services
✔ 5% Off Of Total Replacements
✔ Priority Booking Times
✔ $0 Weekend And After Hours Fees
Contact Anderson Air to Become an Anderson Club Member
Call 479-751-6210 and a friendly representative will help you get signed up.
What’s Covered in a Membership Agreement?
The Anderson Club membership plan is designed to ensure optimal performance of your system, protect the owner from unit failure, and prolong the life of the system. Our membership plan include two visits per year with the following scope of work:
AC / HP System
- Clean & Inspect Condenser Coil
- Does not include Detergent
- Trane/American Standard/Specialty units subject to specialty pricing
- Inspect Evaporator Coil for Cleanliness and Bacterial Growth (**If accessible)
- Inspect Blower Wheel
- Clean & Test Safety Controls
- Inspect Unit Disconnect
- Inspect & Test Contactor
- Test Airflow Static Pressure
- Inspect & Check Ducts For Leakage
- Clean & Check Condensate Plumbing
- Inspect Electrical Connections
- Measure Refrigerant Level (** temperature must be above 60 degrees to record proper level)
- Inspect Motor Bearings
- Inspect Condenser Fan Motor
- Check Condenser Fan Blade Balance
- Measure & Record Capacitor Rating
- Measure & Record Compressor Amps
- Measure & Record Condenser Fan Motor Amps
- Measure & Record Line Voltage
- Measure & Record Temperature Drop Across Evaporator
- Clearance around outside unit
- Inspect Lineset Insulation
- Inspect Condition of Disconnect
- Condition electrical components
- Inspection of coil / fins / and drain pan (**If accessible)
- Visual of supply/ return duct
- Return air sized properly
- Inspect Thermostat
- Inspect & Clean Or Replace Belt (**Belt purchased separately)
- Check & Clean Or Replace Air-Filter (**Air Filter purchased separately)
- Check & Inspect Circuit Breaker
Gas Furnace / Air Handler
- Clean & Inspect Burners
- Inspect Heating Elements and Wire Connections (**If accessible)
- Inspect Heat Exchanger (**If accessible, additional rates may apply)
- Test Gas Shut-Off Valve
- Clean & Check Pressure Tubes
- Clean Cabinet
- Inspect Blower Wheel
- Inspect & Ohm Igniter
- Check Thermostat
- Inspect Vent Pipes
- Inspect Combustion
- Condensate Plumbing if high efficient
- Inspect Electrical Connections
- Clean Flame Sensor
- Measure & Record Temperature Rise
- Measure & Record Gas Pressure
- Perform Carbon Monoxide Check
- Measure & Record Capacitor Rating
- Measure & Record Blower Motor Amps
- Check & Clean Or Replace Air Filter(**Air Filter purchased separately)
- Inspect & Check Ducts For Leakage
- Inspect & Check For Proper Fuse Size
- Inducer motor amp
- Condition HV/LV wiring
- Condition electrical
components - Inspect interior /exterior venting
- CO in duct system
- Adjust gas pressure high/low
- Leak check from valve to unit
- Visual of gas piping
- Drain line /trap clear of blockage
- Blower wheel not out of balance and clean
